How can we help you today?

Welcome
Login  Sign up

Troubleshooting

My air cylinder is not holding pressure.
Make sure the valve core inside the valve stem is tightly in place and is not letting air escape. You can use a standard valve tool to check. Do not over ti...
Wed, Dec 19, 2018 at 8:33 AM
My QuickJack is stuck up in the air with no vehicle.
NEVER raise your QuickJack frames without a vehicle on them! The QuickJack is designed and engineered to be used with the weight of a vehicle on it. You...
Thu, Dec 20, 2018 at 9:47 AM
My QuickJack does not lift the vehicle in the fully lowered position.
Your QuickJack requires a little bit of space to get going to raise a load. It cannot raise a full load from a completely flat starting position. The issue ...
Thu, Dec 20, 2018 at 9:50 AM
There is no pressure coming from the pump.
Try priming the pump. Learn how by reading this article.
Thu, Dec 20, 2018 at 9:58 AM
QuickJack frames are not raising evenly with or without load.
If the QuickJack frames jerk or lift unevenly while going up with the weight of a vehicle on them, lower the vehicle back down to the ground and then try it...
Thu, Dec 20, 2018 at 10:05 AM
QuickJack frames are not lowering.
If you've properly and safely disengaged the safety locks and the frames still do not lower, there are a couple things to check: NOTE: If there is ...
Thu, Dec 20, 2018 at 10:36 AM
The frames make weird noises as it lifts or lowers.
Lubricate hinge points using white lithium grease. QuickJack recommends using white lithium grease (or equivalent) and a grease gun with an appropriate ...
Thu, Dec 20, 2018 at 10:53 AM
Quick-connect fittings are becoming increasingly difficult to connect or reconnect.
Pressure is building up in the hydraulic system. To prevent this, hold the Down button on the pendant control for several seconds after the frames reach the ...
Thu, Dec 20, 2018 at 10:55 AM
Buy the QuickJack

Portability, safety, and convenience in your garage.